#ampwiringkits

  • Component Speakers

    Hertz MILLE MPK 165.3 PRO – 16.5cm 6.5″ Component Speakers 220W

    £383.99 Add to basket

    The MPK 165.3 car audio speakers system has been designed to ensure a wide low frequency response, even in cars with no space for a subwoofer.

     

  • Speakers

    Hertz MILLE MPX-165.3 PRO – 6.5″ 16.5cm 2-Way Coaxial Speaker 200W

    £275.99 Add to basket

    The coax tweeter concentric to the woofer of the MPX 165 car audio coaxial speakers allows for one single linear-phase emission point, for a natural timbre providing a detailed sound stage. Thanks to the “Center Tuning Duct” geometry, the tweeter resonance frequency is especially low and the employment of damping materials for the inside provides for a linear acoustic emission. The acoustic lens optimizes its off-axis response, which is typical with door installation of coax speakers; besides, the 36 mm diameter woofer generates deep and controlled bass frequencies.

  • Speakers

    Hertz UNO X165 – 16.5cm 2 Ways Coaxial Speakers 220W

    £83.99 Add to basket

    The 6.5” two way coaxials are available X 165 features a special designed tweeter faceplate optimized for exceptional off-axis performance to ensure a linear frequency response when installed in a factory replacement setup.

    The pressed-paper cone treated with water-repellent along with the foam surround provide a very high SPL and extended low frequency response, to obtain a rich sound even when driven by the OEM head unit.

    The 25 mm(1ˈ) woofer voice coil driven by a high-flux density ferrite magnet offers a highly dynamic power handling for a powerful undistorted sound.

    The easy-to-install DIN size basket, protected by an abrasion-resistant dust paint, makes the factory speakers replacement a snap.

  • Amps

    JBL CLUB A5055 – 5 Channel Car Amplifier 50W RMS x 4 + 500W RMS x 1

    £443.99 Add to basket

    Solid performance
    Not into the hassle of wiring up multiple amplifiers? JBL’s Club A5055 five-channel amplifier deliver 50 watts RMS to each of your front and rear speakers, plus up to 500 watts RMS to your sub, all from a chassis that’s the size of a book. Or, you could use the amp in 3-channel mode to power a pair of high-performance speakers with 140 watts RMS each as well as 500 watts to the sub. The Class D design ensures the amp’s high output won’t put too much strain your vehicle’s electrical system.

    Compatible with almost any system
    Speaker-level inputs and signal-sensing turn-on allow this amplifier to simply integrate into almost any system, even one using the factory radio. Separate high- and low-pass filters on the front and rear channels tune the sound to perfectly fit your speakers. The subwoofer channel features a low-pass filter, bass boost, and phase switch to tune the bass for your subwoofer. A wired remote lets you control the sub level from the front seat.

     

    Product Features:

    • 5-channel car amplifier
    • 50 watts RMS x 4 + 320 watts RMS x 1 at 4 ohms
    • 65 watts RMS x 4 + 500 watts RMS x 1 at 2 ohms
    • 140 watts RMS x 2 bridged at 4 ohms + 500 watts RMS x 1 at 2 ohms
    •  front and rear channels:
    • Class AB amp technology
    • variable high- and low-pass filters (32-320 Hz, 12 dB/octave)
    • subwoofer channel:
    • Class D amp technology
    • variable low-pass filter (32-320 Hz, 12 dB/octave)
    • variable bass boost (0-12 dB at 45 Hz)
    • phase switch (0, 180 degrees)
    • wired remote bass control module included
  • Speakers

    JL Audio C1-650X – C1 6.5″ (165 mm) 2-Way Coaxial Speaker 225W

    £127.19 Add to basket

    C1 woofer drivers benefit from proprietary FEA modeling and JL Audio’s expertise in low-frequency driver design.

  • Speakers

    JL Audio C2-650x – 16.5cm 6.5″ 2-Way Coaxial Speakers

    £263.99 Add to basket

    For a car speaker to excel it must be thoroughly engineered in all areas. The woofer design must deliver sufficient efficiency, smooth mid-range response and good low-frequency extension. The tweeter must be smooth off-axis, exhibit good extension and be non-fatiguing, while the crossover design must seamlessly blend the sound of the drivers so that the end result is clean, realistic audio performance.

    In designing the new C2 Coaxial and Component Systems, we have drawn from our vast experience in woofer design as well as the tweeter technologies employed in our world-class C5 component systems. The resulting products deliver a compelling performance solution at a price within reach of any enthusiast seeking a great listening experience.

  • Amps

    Powerbass AWS-16SP 16 Gauge Speaker Wire 1 Metre

    £3.47 Add to basket

    FEATURES

    • 500’ 16 Gauge Speaker Wire
    • 1 Metre
    • 60 Strands x 2
    • 50% OFC/50% CCA Blended Wire
    • Flexible Blue Satin PVC Insulation Jacket
  • Amps

    Skinz Sound Damping Material- Shop Pack 7 Sheets

    £43.19 Add to basket
    Stop fighting engine rumble, speaker rattle, road noise and buzzing vehicle parts!
    Apply SKINZ Sound Deadning to your vehicle’s resonant surfaces and enjoy improved clarity, loudness and bass response from your car stereo.
  • Amps

    Stinger Select SSK0 – 1/0 Gauge 1500W Complete Amplifer Wiring Kit

    £82.68 Add to basket

    Featuring Ultra Flexible CCA cable construction for excellent current transfer to power hungry amplifiers on a budget. Quality twisted pair interconnects for noise free signal transfer. Also includes , remote turn-on ANL high current fuse holder and ring terminals for a complete installation package.

    Kit Contents:

    • 17FT Matte Blue Ultra Flexible Power Wire (CCA)
    • 3FT Matte Gray Ultra Flexible Ground Wire (CCA)
    • 17FT Twisted Pair RCA Interconnects (OFC)
    • 17FT Blue Remote Turn-on Wire (CCA)
    • 1pc. High Current ANL Fuseholder with 150A fuse
Shopping Basket

Manufacturer

Models

CategOries

Scroll to Top